JoseO

[tamanho=120] [b] [u] AFC, F / S ou FSB: [/u] [/b] É um sinal que vai para a selva e é usado em algumas televisões para o acoplamento horizontal, se não existir É possível conectar este pino ao aquecedor ou...

Pare de andar no carneiro que não é a causa, você tentou outro monitor? talvez isso seja culpa e não o pc

How much voltage in the + B?

If it is for the area of rectification and filtering of the source if you can put one of the immediate superior value, it is not necessary that the two are equal since one does not depend on the other...

It is a failure of T-Com, those TVs all over time that card arches for some reason and ends up making contact with the chassis making a short that damages certain SMD components, transistors, resistors, fuses etc., it is in...

Faced with this type of failure, the screen setting should not be modified to the first one (usually I do not like to do it unless it is necessary) because if the TV was working well until it failed it...

When you turn on, does the image look good? What voltages do you have on pins 2, 4 and 6 of the Vertical IC, does it have good dissipation? Sometimes the cause of damage is often a poor dissipation, incorrect...

Desolda the emitter of the Q804 and check if you have the 3.3 Volt in that pin, if so you must follow that line of the transmitter until you find the component that is causing the overconsumption that makes the...

Good afternoon friend the direct replacements between them are: FA095WJ BSC21-2604S JF0501-32601 BSC24-2688S

[b] You have not done the test of the yoke that we have suggested, you have to discard several parts before going to change regulator, if you have the wrong yoke you can mount all the regulators you want or...

You must put fast diodes in that area of 2 or 3 amps since if you place a common rectifier diode it is obvious that it will burn them.

Xq you do not raise the chassis number or what components you use, maybe some of us have some data that serves that TV, those Chinese TVs use practically universal multi-brand chassis, x therefore a Chinese TV so is of...

Although the source voltage is very close, the correct value is 110v, I think you should check the control part of the source, maybe you have some altered resistor, maybe you get 24v to the vertical IC, it could also...

Q such a friend, the pin out of that Fly is: 1 collector 2 + 180V 3 + B (130V) 4 GND 5 24V 6 12V 7 GND 8 ABL 9 Heater 10 22V http://www.kueyar.net/flybacks/flaybacks_list.php?pagesize=500

What I can tell you is that it is in the return of the LEDs, and it does not put resistance, rather some (s) are removed or you replace the set with some other of the suitable ohmiaje until reaching...

Have you tested the integrity of the disk? With what tools? sometimes it happens that there are sectors that when they begin to degrade do not respond fast (Delay) making the data recorded there does not flow at the necessary...

It is a USB modem for wireless Internet that uses a SimCard GSM line, what happens is that people began by calling them all those modems, Movistar or Movilnet just by the commercial name that Digitel gave it at its...

Each person works as he wishes until a stumble is carried by a stubborn, nothing like a lamp to detect short circuits, and if so, the tools (tester or multimeter) are used to find where the problem is and solve...

[size=120] [b] [u] AFC, F / S or FSB: [/u] [/b] It is a signal that goes to the jungle and is used in some televisions for horizontal engagement, if it does not exist It is possible to connect this...

Stop walking the ram that's not the cause, you tried with another monitor? maybe this is the fault and not the pc