⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Tube TVs

Samsung TV has horizontal stripes across the screen

luisalejandro
hace 5 años
hace 5 años
Samsung Model CT2288BL
Victor E
Victor E
65.783
hace 5 años
hace 5 años
the control of the screen in the flyback is very high, lower it a bit by adjusting the potentiometer that says screen in the flyback.
luisalejandro
hace 5 años

I already did, regulate the potentiometer of the screen low and it looks blank or vice versa

Responder
Victor E
Victor E
65.783
hace 5 años

very likely that the screen control is open or bad in the flyback. in the socket of the tube or screen where it says G2 measure if the tension varies gradually or does so abruptly.

Responder
nicomena2015
nicomena2015
9.501
hace 5 años
hace 5 años
Hello colleague: ... measure in the positive of the C412 if the 180v are present for the amplifiers, video ... if they are measured if they reach the socket of the tube ... if you do not have the 180v in C412 change the C412 of 22mfx250v ... measure and comment what voltage you have now on the C412 ... greetings !!
luisalejandro
hace 5 años

hello thanks for answering .... medi the c412 and m throws 34.2v. I measured a resistance that is about 22 ohm and seems open

Responder
nicomena2015
nicomena2015
9.501
hace 5 años

you don't have the 180v in C412 ... deves haver 180v ... as I explained, change the new C412 x one of 22mfx250v ... it may be exhausted or dry ... comment if you increase the tension when changing the C412 ... R599 ed of 22ohm ... but the voltage of the 180v must appear in the positive of the C412 q, comes from the D405 and pin 5 of the fli-bak ... comment ..

Responder
luisalejandro
hace 5 años

SOLVED friend thanks for guiding me. Indeed the root of the problem came from there. The resistor R599 of 22 ohm was open, I changed it and the TV is working correctly. Thanks to all comments. Regards..

Responder
JoseO
JoseO
1.634
hace 5 años
hace 5 años
Faced with this type of failure, the screen setting should not be modified to the first one (usually I do not like to do it unless it is necessary) because if the TV was working well until it failed it must be verified that it happens before moving it , many people after moving it do not return it to the correct level and the TV is working badly, in this case the most sensible thing would be to verify the correct voltage of the video amplifiers, or cracked welds on the socket card, notice that the Image is presented with a certain halo on the right, typical of the 180 Volt fault, very common in these TVs.
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis