Primeiro verifique se a tomada tem o terra correspondente. Mas você deve colocar um dardo de pelo menos um metro e meio e conectar a terra do dvr lá. Então você mede com um voltímetro entre a terra e o...
Tente aterrar o DVR. Essa equipe tem um parafuso de volta para isso. Em seguida, desconecte todas as câmeras e adicione uma por uma.
Aconteceu comigo quando o cabo do ponto de entrada está mal armado com uma falha intermitente ... redefine a antena. Verifique o arquivo
Olha bem ... esse dvr deve ter a porta 485 ... como você vai convertê-lo para ip? Que modelo de ptz é esse?
Eu acho que há uma confusão com ip. Esses dispositivos são analógicos ... você só precisa de dois cabos utp para cada câmera. Para essas distâncias, você precisará de balunes ativos. Nesse caso, a categoria do cabo não importa, se...
O problema com essas câmeras é que elas alteram a porta aleatoriamente. Você deve entrar em contato com o distribuidor em sua área e atualizar o firmware.
Olá, tenho uma sirene mp300 magnetodiânica com flash, é com um painel A2K8 NG a 12/13 metros. Ligar a sirene não liga o flash. É simplesmente conectado, a partir da saída do painel da campainha. Normalmente usamos o modelo mp150,...
Ele nunca o "verá" ... eles são de frequências diferentes.
First check if the outlet has the corresponding ground. But you must place a javelin of at least a meter and a half and connect the land of the dvr there. Then you measure with a voltmeter between earth and...
Try grounding the DVR. That team has a screw back for that. Then disconnect all cameras and add one by one.
It happened to me when the poe cable is badly armed with an intermittent fault ... resets the antenna. Check the file-
Look well ... that dvr must have port 485 ... how are you going to convert it to ip? What ptz model is it?
I think there is a confusion with ip. These devices are analog ... you only need a couple of utp cables for each camera. For those distances you will need active balunes. In this the category of the cable does...
The problem with these cameras is that they change the port randomly. You must contact the distributor in your area and update the firmware.
Hi, I have a magnetodimanic mp300 siren with flash, it is with an A2K8 NG panel 12/13 meters from it. Turning on the siren does not turn on the flash. It is connected in a simple way, from the bell...
He will never "see" it ... they are of different frequencies.
Prueba cambiando el cable de red.
Podrias adquirir un tercer dvr y embeber los canales de los 2 actuales. Deberian estar en red los tres.