Galego

Olá ... é por isso que você não drena o canal que coleta a água que entra no fundo e a água que transborda ou com o movimento do ar do ventilador espirra para fora ... se você tiver uma...

Connect it in a triangle, you feed in two terminals with 220v ... and between e you have free and one of the other two put a permanent 50uf capacitor ...

About 2000v in high and between 2 and 3v in which he goes to the filament, I think I remember ... I haven't repaired one for years ... greetings

Nothing will happen, it will work without problem ... your device will consume 1 amp from a source that can supply up to 10 amps ... regards

That may be due to the fact that at some output a short circuit is occurring, the source tries to start by activating the oscillator but since the voltage at the output is not maintained it is disconnected for protection...

Hello ... those that have the letter A, are the ones that will end up replacing those without A. That does not mean that both do not work well, but that it is the same a little more improved in...

Hello ... With the Ldmicro program you can program both the arduino (atmega) or the pic with ladder language ... It is very intuitive and easy to use. It has not implemented the 2-wire bus i2c but the serial communication....

That seems to be a sign of dislocation of the covers or bearings in poor condition ... the rotor is touching you with the stator ...

Hi ... you can't ... it would be a low input voltage fault ... in regards to supplying a three-phase inverter with single-phase current if you can always provide that the voltage is the one indicated by the inverter and...

The electrolytic capacitors that are at the entrance and the oscillating circuit that commutes the reducing transformer are usually damaged ... they are usually eight legs or if it is in four-pin smd type transistor ... greetings ...

Good ... It is not my intention to boycott this answer but I think it is not correct at all .. That the motor puts 220/380 means that it can work with a three-phase voltage of both 230v and 380v,...

Holaa ... Unplug it and empty the water completely before removing it, since the anode is in direct contact with the water ... greetings.

Hello ... they are capacitors .... As you can see, usually in the screen printing of the plates, they usually give us a hint of the type of component that is ... C for the capacitors / capacitors, a D...

[img]https://adjuntos.yoreparo.com/imagen_post/0004/83/0f3a250e70117749ae5ddc971bd44cee6e806165.jpeg[/img]

Yes ... you must clean them ... I could, if possible, cut the damaged piece, until the copper wires are perfectly visible ... and if they are the battery, clean the ties, or better replace them and cover them with...

Hi ... I think it is viable, but it has the disadvantage that by adjusting one, you modify the others ... more effective would be to make independent circuits on the same PCB, thus having separate regulations and in the...

It may also be because the evaporator is blocked and then does not evaporate properly and refrigerant arrives at the compressor inlet ... or if it has a thermostatic valve, which is defective and does not regulate well and there...

Hello ... I have one with lower benefits and it works pretty well ... I use it for diagrams, plans and 3d design ... I also tell you that I do not use rendering, because that does consume a lot...

Hello ... you have to turn the rotor, disassemble it and change its position ... greetings

You have to connect it as indicated in the diagram and set a time with the set key. Every time you run out you must press restart to start a new cycle ... Greetings.