⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Cars and trucks

My car does not turn on after using it

Jesús Marroquín
hace 6 años
hace 6 años
Hello, once again asking, I have a dodge neon 95 and no problem is that in the morning it works very well, without problems, I go to school and to work, without problems, but once it cools (usually when leaving work ) The car does not start and after trying to turn it on for as long as 30 minutes, the car turns on, advances a few meters and goes off, I try again, turn on and as if nothing happened. I hope you can help me. Thank you
Mangel HH
Mangel HH
19.786
hace 6 años
hace 6 años
Hello Jesus. You have a false contact in the general management Asd relay, or the crankshaft position sensor has dirt and causes it not to take movement reading towards the Ecu. Salu2.
Jesús Marroquín
hace 6 años

Thank you very much, yesterday afternoon I changed the relay of the car shoot down and it seems that it worked, I gave it a spin and as if nothing, I'm really afraid to take it out hahaha

Responder
Mangel HH
Mangel HH
19.786
hace 6 años

You will not have any problems. The Asd relay manages the operation of the plant by means of the earth (very important) and the entire injection circuit, fuel pump, etc. On the other hand, this relay has a protection fuse, it is important to keep the contacts perfectly clean with contact cleaning spray, the moisture is insulating causing rust that causes intermittent failures and difficult to locate.
Regards.

Responder
Jesús Marroquín
hace 6 años

Hello, I reopen this issue because for a while it worked fine, but the same thing happens again, the mechanic mentioned that it was the gasoline pump that had to be replaced, while another MAP sensor, I checked the contacts and they are clean

Responder
Mangel HH
Mangel HH
19.786
hace 6 años

What does the mechanic say, check the fuel pump pressure? On the other hand, the fuel regulator is integrated into the pump module, which ultimately maintains the pressure at 49 Psi, or there may be dirt in the tank (especially if it is kept below the fuel level).

Responder
Jesús Marroquín
hace 6 años

No, by commenting on the symptoms, he assumed that it was the bomb and did not want to review more, obviously I did not allow him to try to "solve" the problem until I investigated a little about it and see it as a possibility

Responder
Santoline
hace 6 años
hace 6 años
I bought a used car and it gave me the same problem at six months, and it was because the contact was not clean, they told me,
Jesús Marroquín
hace 6 años

Sorry, I had not noticed your answer, which contact was not clean?

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.93
(14)

Curso Reparación de Equipos de Audio de Alta Fidelidad

Maximiliano Resch
$ 60 USD
$ 20 USD
4.6
(10)

Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off

Yamil Alarcón
$ 29 USD
$ 12 USD
4.71
(7)

Curso TV OLED y QLED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 29 USD
$ 10 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis