⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Cars and trucks

Ford ranger 3.0 has no route power

ALFREDO GUEBEL
hace 6 años
hace 6 años
Hello friends, I have a Ford Ranger 2006 Power Stroke 3.0, en route with the throttle in depth does not exceed 110 km per hour, to pass a truck it costs a lot, this began to do about a week ago. In the city there is no lack of power, it is normal. I thank you if you can help me with this problem, thanks
MJGTSAS
MJGTSAS
4.613
hace 6 años
hace 6 años
Check the gas oil filter that is not dirty and partially clogged.
ALFREDO GUEBEL
hace 6 años

Hi, thanks for your opinion, tomorrow I buy a new filter and I change it and see what happens after I tell you

Responder
Mangel HH
Mangel HH
19.786
hace 6 años
hace 6 años
Hi Alfredo. Fuel flow is lacking when the engine requires it at a higher speed. The system is common rail, it requires the scanner to observe two basic conditions, the fuel pressure used by this system and that above all will be related to the fuel pressure sensor in the rail that is the variable flow meter that the Ecu sends based on the signal received by it. Attached. Salu2.
ALFREDO GUEBEL
hace 6 años
hace 6 años
Hello friends, it seems that the problem was solved in a strange way, with the truck running but stopped, it gave accelerated up to about 3000 rpm and failed as if it lacked fuel or air and on the way it did not exceed 100 km / h. It occurred to me to take out the air filter, which I did not doubt because it is quite new, and without the filter I gave it some accelerated up to a little more than 3000 rmp, and surprise, it did not fail more, step followed I placed the filter again and tried another time and the truck didn't fail. Then I decided to go out and try it on the route and pleasantly check that it is going well and I get up to 160 with a good reaction and I sure gave more but I tried up to that speed only. If anyone has any idea that it could have been, it would be good if they would comment and if not, I hope someone will serve. I suspect that it could have been the air flow sensor that was dirty and when the filter was removed and accelerated it was cleaned. Thank you for your comments and a hug.
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.84
(25)

Curso Práctico de Reparación y Bobinado de Motores Eléctricos

Héctor Castiñeira
$ 60 USD
$ 20 USD
4.25
(8)

Reparación de Placa Main TV LED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 40 USD
$ 20 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis