Daewoo cooler model dfr 9010s dfr 9010d
Hi Jose, have you checked the thermal elements: relay, thermal and capacitor if you include it?
If I have placed Reyar Thermal and Capactor and everything marks well what happens that the refrigerator does not cool and to discard the compressor gas, connect it directly without the elements that turn it on and I start the engine for about 2. O 3 minutes and swim
And it suddenly turned off and only resounded but the engine was no longer heard and I touched the compressor and it was very hot
Regards
roberto ru
Jose checks the starter and work coils with tester or multimeter, as well as not having any of those coils grounded. There are tutorials on youtube on how to do it. But for the data you give, apparently the compressor is damaged. Check and I'm still watching the results.
Jose checks the starter and work coils with tester or multimeter ***, as well as that any of these coils are not grounded. There are tutorials on youtube on how to do it. But for the data you give, apparently the compressor is damaged. Check and I'm still watching the results.
The coils check between the common coil and average work 3 ohms and common and medium start 12 ohms and between work and medium start 15 ohms after checking the coils I connected it directly and it started well and a few minutes went off I just left sumbando and I disconnected but the compressor was very hot and I measured coils all measured the previous ohsm less common and worked low at 1 ohm
Hi José, try starting the direct compressor again and measure the amperage. If the amperage is high, no doubt the compressor is damaged. Although, once the compressor has been disconnected from the system, a final test can be made to start it directly. And if after a few minutes it works normally, then the system may be clogged. Good luck, and I'm waiting for a comment.
Hi Roberto Ru
I already connected it directly and the compressor and it didn't start anymore. He only made a small short in the contact at the time of connecting and the work coil its amperage is 1 ohsm low and from there I no longer start at all
Greetings and thanks for your answers
The compressor is no longer useful, you must replace it and assess whether it is worth investing in such repair. You're welcome and greetings back.
José, how well the information served you is the purpose of the page. Greetings and what technical advice is offered.
Ok and the compressor refueling filled with gas and materials would come out a lot of budget
Regards FERMIN 007
If you buy it new, then if it is expensive, plus the material and workmanship, but if the refrigerator is still worth it, well go ahead, regards
¡Aprende a reparar con estos cursos YoReparo!
