Chinese industrial foot fan does not turn on
I did it. the resistance that I said m equiboq. was the thermal fuse ... this time ... it doesn't work that way either
It does not emit a buzzer and the blade becomes hard, if it turns smoothly it drives the blade with the hand if it does not conserve the impulse or made the change of speeds the winding is damaged
It has no impulse or with the change of veils ... moving the plug cable a little and wiggling it emits a small noise but does not turn. something strange happens to me with the plug when I disconnect it touch with the hands its tips and I grab milk current It must be the boot capacitor that was discharged but because from the plug that is good or bad
It is rare but it happens, 1 in 100. With respect to the winding it must have damaged part of its magnetic rectitude (intensity of the electromagnetic field) hence it does not rotate the axis.
If it is very strange, I thought it was to add more fine washers to see if what it was is the feeling of nothing, the layer will load what I also saw, when I brought it to the fan I had the cables from where the layer was installed. If that has influenced that, if that happens for a while, I will give it one more test and if nothing happens, I will unsubscribe it, and if I do not work at all, thank you for your response, I comment after what happened.
I already know all that and nothing. Lobq m yama the attention is that the shaft brought a rubber and a washer on each side of the axes and that neither of the two washers are made of fiber. They are plastic.
¡Aprende a reparar con estos cursos YoReparo!
