good afternoon someone who can give me some tips I am starting to perform rgh for the consoles, I have already done some but I have a problem with one I do the reading of the nand and everything well, I comment that it is a console with voltage 12 volt, 9.6 amp 5 volt 1 amp, with internal memory of 4 gb samsun brand, remove the heatsink and it is V1; when performing the flashing of the nand it marks everything perfect but at the time that I give the key to continue it does not turn on so I reset the nand again and if it turns on again, I performed the procedure again and nothing did the same to me again I am using an SD memory as a reader of nand according to what they taught me, any comments on this I will thank you greetings