⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Cars and trucks

Vw Voyage starts in 3 cylinders then regulates well

sepilrat
hace 6 años
hace 6 años
Goodnight. I have that problem, the car starts failing, but in a few seconds it is composed. It is a voyage 1.6. With CNG. I was thinking of changing spark plugs, and wires, but I want your opinion first. I suppose that if I have problems with the spark plugs, the fault will be constant. any ideas? Thanks since now
Inter
Inter
4
hace 6 años
hace 6 años
Indeed, it looks like spark plugs or wiring. First of all, we would check that the cables are tight in their ends, if the problem persists, the first thing would be to remove the spark plug, if it is bad, change, if it would not be a matter of seeing the condition of the cable. Once the fault in the different components of the electrical distribution has been ruled out, if it remains the same, we could think about some small injection failure. Luck!!
GustavoCarp
hace 6 años
hace 6 años
Was the EPC light on the board turned on? How many km is it? Did the coil change it?
sepilrat
hace 6 años

Good day. I changed spark plugs. It continues to fail even though it is better.
I changed the coil a couple of years ago. He did not light epc. turn on the checkengine but that was since I put gas.

Responder
GustavoCarp
hace 6 años

The fault makes you when you start gasoline and then not? Or with gas also fails? If the check engine stays on, it is because it does not have an emulator in the lambda probe, it should have been placed.

Responder
sepilrat
hace 6 años

Good day. Only when you start gasoline. After
Go well to gasoline until
That passes to gas and goes smoothly. When it starts cold it shakes a little and then it goes well. If i come back
To start after stopping it does not fail, only cold in the morning or after several hours of standing. But in the morning it is more noticeable.

Responder
sepilrat
hace 6 años
hace 6 años
The board was blown. I had water in a cylinder. That's why I failed. Thank you all for the answers.
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.25
(8)

Reparación de Placa Main TV LED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 40 USD
$ 20 USD
4.6
(10)

Curso Localización de Fallas en Refrigeración en Heladeras/Neveras On/Off

Yamil Alarcón
$ 29 USD
$ 12 USD
4.64
(45)

Curso Tecnología Inverter - Fabricación de probadores y herramientas

Yamil Alarcón
$ 240 USD
$ 40 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis