⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Tube TVs

Help how to know if a str w6554a is good!

Televisor LG 21FJ4AB

Televisor LG 21FJ4AB

Delek12
hace 5 años
hace 5 años
Help friends, I have a lg tv mod. 21fj4b-l3 that does not turn on and I suspect the regulator str w6554a since it enters 160vdc but takes only 15v I have reviewed the nearby components but nothing. Thank you
Yunior Delgado Blanco
hace 5 años

how much do you have in pin 4?

Responder
victor flores martinez
hace 5 años

where do you get those 15v? in the filter + b? .... remove the TSH see if you reset the + b

Responder
Delek12
hace 5 años

Remove the horizontal, but still take only 10v

Responder
victor flores martinez
hace 5 años

Does the standby LED turn on?

Responder
Delek12
hace 5 años

If it turns on. In the main filter there are 160v, but a line that goes from the str to the primary of the transformer has no voltage

Responder
Yunior Delgado Blanco
hace 5 años

Talk about pins, let's see, with the Negative of the multimeter to pin 1 that there is ?, the V pin 4 ??

Responder
Delek12
hace 5 años

There are 156v on pin 4

Responder
Yunior Delgado Blanco
hace 5 años

I don't have the exact pinout of this specific one, but that STRW family almost always has the same legs ... 1 transformer and at V +, 2 there is not, 3 resistance 1ohm, ground, 4 start, high resistance 270k eg at v + , 5 vcc, 6 optocoupler, is that so ??

Responder
Delek12
hace 5 años

I already checked and I had a bad resistance R421, when replacing gave me + B and already turned on. Thanks

Responder
victor flores martinez
hace 5 años
hace 5 años
Hi Since the standby LED turns on, it indicates that the source is working, maybe everything is not ok, but it works measure voltages in C814, C831, C826 and C838 upload results .... -Place the black tip of the multimeter in the armored housing of the tuner and the red tip at the points to be measured-
victor flores martinez
hace 5 años

then the source was OK and protected by failure in OCP

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis