⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Tube TVs

i have a daewood DTQ2059FS

Televisor Daewoo DTQ2059FS

Televisor Daewoo DTQ2059FS

8 Soluciones
10 Reparaciones
joaquin
joaquin
joaquin
17
hace 5 años
hace 5 años
it will not be fully up The same will not be totally up or down, that is, there will be no horizontal
Comentar
neg2013
neg2013
neg2013
14.048
hace 5 años

Good: Upload a photo of the fault, at least I do not understand how it describes the fault, I can imagine that it lacks vertical height. Or have a box on the screen?

Responder
victor flores martinez
hace 5 años

measure voltage in each of the vertical ic pins and upload results

Responder
ratonelect63
ratonelect63
ratonelect63
5.308
hace 5 años

that ic vert uses .. that fault is normal if you use split source. missing one ¿¿do they carry in series a r .1oms open

Responder
joaquin
joaquin
joaquin
17
hace 5 años

the image looks good which does not fill the screen completely as it is to have it up and down the image there is a black stripe.

Responder
manolito1386
hace 5 años
hace 5 años
Look for cold welding in the vertical area, that can be from a devalued R, capacitors, to a dry filter, I recommend searching flat and checking voltages on one occasion I had a similar average defect and it came from the source ...... ....
Comentar
joaquin
joaquin
joaquin
17
hace 5 años

thanks cold welds

Responder
nicomena2015
nicomena2015
nicomena2015
9.501
hace 5 años
hace 5 años
hello colleague: see if it is chassis (CN52N) ... notice or measure if 25v reaches (pin6 and 3) of the vertical lc TA8403K ... if the tension is correct check or change the C304 of 2200mfx35v ... if no results change the R308 of 2.2ohm x a new ox one of (1.8ohm 2w) ... with this change of R308 you would have to open the vertical well ... there is only one pre-set of adjustment and it is the v-center RV302 ... comment results ... greetings !!
Comentar
victor flores martinez
hace 5 años
hace 5 años
Hi if you already changed the filters of the vertical stage adjustment
Comentar
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis