tv ken brown kb-2-29slim-b CHASSIS psw29uta ---- 1b replacement coil
hoal and I can put one that looks like it or has to be the same is from the horizontal area
hoa victor look I have these coils. FEC 9415. other. SY195. other. 2111G other. K-20N.other. L-76 other. w96.other. L-45.other. 013N1.other. L50 other. L45 other. L-76.other. TRL 2000. other. L680 well these are all I have I put the L680 I do not know if it goes or not that I put here tell me if any of these or not is the one that left just said above L451 I can put any of these victors
Hi, Victor, I'm sorry that I didn't answer before but I couldn't get the coil anywhere, so even if the TV doesn't start, I change everything. horizontal. vertical. The source regulator. The main capacitor. The retreating bridge. the ptc. primary and secondary capacitors. the tesmistor. and nothing does not start the source measured in the capacitor of 220uf by 160v and there it measures 168v I do not know if it is right or wrong it happens that I do not know much in measuring trends but there it gives me that tendency that you decided friend
on the plate is the c532 near the choper in the secondary next to a ceramic resistor came so goes that capacitor
if the tension is high because when I download the main capacitor, that is, I short-circuit it with the screwdriver it explodes, it is seen that it has too much tension if it does not do that to me I know that it does not discharge like that but well it is discharged with the welder well it happens that I bought all the polyester capacitors that are close to the horizontal but I still did not put them because I am with another TV when I measure the trend I tell you if now friend I can ask you another question about another TV
Hi Victor, well, I'm going to measure the voltage you told me, but well, I don't know very well, I have to put the tester in direct current at 200V and the positive of the tester goes to the collector and in negative to the tuner, it's fine like this
hello victor excuse me not to answer but i was struggling with this tv that didn't even tear off the source well look i changed a resistor that is the R551 and the vd531 which is the RGP30J and now i start the source but the flayback cranks when i turn on tell me victor It will be the flayback that is bad or it may be something else the TV does not turn on if the source started but that is why I ask you it can be the bad flayback that crazy