tv cyberlux 20 chassis 34BI
Hi. Do not comment if the ST LED turns on. Comment everything you did to try to make the TV go so you do not advise what was done
You must measure the other source output voltages.
5v memory micro thinkers, etc.
Disassemble the TSH measure it to see if it is not broken. And plug in the TV without it and see if it turns on the ST and power LED to measure the + b. I think the voltage of DE 88V is in ST mode. I commented everything
good afternoon colleague forgive the staby can not turn off the horizontal transistor and does not turn on the led in the + B of the cuper I have 85vts deaf the horizontal transient and disconnect the + B from the flyba and turn on the led I measure voltage and the line of + B arrive 104v I changed the flayback for a new one because I thought it was damaged but there is no voltage and in the source filter there are 145vts I changed the coupler several capacitore that filter the ignition voltage please hope someone with more experiences helps me.
When disconnecting the power pin to the flayback corresponding to + b. Load on + b?
104v is fine since this tv works with 103v. The one that is a little reduced to my criteria are the 145v of the primary source electronics.
Apart I think the TV is with PW order. otherwise you would not have that + b. I don't know what friend Victor thinks.
I have not been able to solve it I am changing the diodes of the source and the nearby components such as capacitors and resistors because the voltage does not pass for the secondary and that has got me tangled up.
You are astray. If according to your contribution the source regulates in - 104v.