20180131_142442.jpg [906.72kb] 20180131_142600.jpg [1.02mb] Hello, best regards to colleagues ..
friends I have doubts about how to read these capacitors if they can help me since I am replacing all the capacitors of the Sony tv source ... oh I send you picture I have 3 of those that are small and say only 224 says nothing more .. and I have on the board also 3 big ones that say 103 K 630 N ... Thank you
partner. the 224 reads the same as a resistance 220000 nanos. this is equal to 0.22 uf) from the point to the right it has to have 6 digits.- now 103 is equal to 10,000 nanos.- it is equal to 0.01 uf.- i will send you some pictures of capacitors. Greetings . Felipe Ascecio 
What are you talking about, Vallarta friend? If it is the question of the post refers to the capacitors ps leave you a comment saying that they will open a solution to give you the. . In the same way the friend Felipe made a good contribution ... and if you refer to the Sony source repair ps of course that if I have been reading it for days ... the imformation that all the colleagues give are of use for me. Thanks to all colleagues ...
I mean that if you want to learn read more, the solution you gave is in the information you leave, just like the information that Juan Soler leaves extracted from the service manual that I do not understand why it is rated with -2 if you read the information sent you will notice that they took it out of the information sent, read more colleague .... greetings.
Friend, I already installed the transistors but I want to check if the output voltages are correct, which tells me on the 115v E 16v E board but I don't know where to grab land .. will it be where the letter E says, are those lands?
Indeed "E" (Earth) is earth, in the same way that "GND" (Ground) is, you can take this point as a reference or common point to take the voltage readings on the secondary side of the source. To ensure the correct "ground" (ground), it is best if you support the negative tip of the tester (DMM or DVM) on the shield of the tuner or tuner.
Thank you, my colleague, what happens is that this source is separated from the other board where the tuner and the TSH and the fly etc ... but already installed the PS transistors at the output I do not mark any voltage and check that source well. .. but I think it will be for another post ..... thanks and regards to all colleagues ....
