Horizontal..NOBLEX model ... 20TC627
Hello ... there is change the horizontal Q401 d2499 and change the electrolytic capacitor of 160v x 1uf and I put another value of 160v x 33uf and I go but with a vertical line and I do not know what to do if someone could guide me from many thanks
Ok ... I measured the integrated chroma leg 28 to ground that says H vcc (says 9v) medi and there are 8v
Exactly ... that resistance is left by Mr. I do not have another one from another chassis and today is a carnival holiday I will have to wait until tomorrow to buy one leave it because in the measure of measuring 15k it measures me 18.08k I do not know if that will be the problem the ones that I have spare are 1 ohm of 1/2 watt
good morning leonardo good day victor e measured his yoke how much hom measures would be the one who opens the width
The yoke measured it and measured me 4 ohms and well I'll see if I get a resistance of at least 15k
I DON'T UNDERSTAND BECAUSE VICTOR HAS GIVEN THE CIRCUIT CORRESPONDING TO HER PLATE AND YOU REQUESTED THE VALUE OF A RESISTANCE BUT IT CORRESPONDS TO YOUR TV THE CIRCUIT THAT HAPPENED THE VICTOR COLLEGE AND IF THAT IS SO, PLACE THE CORRECT RESISTANCE
Ok, I'm going to try it ... there is no risk of burning something if I put a 1.8k 1/2 watt?
VICTOR E TOLD HIM 1-8K THAT IT WOULD BE 1,800 HOM PUT SERIAL RESISTANCE UNTIL YOU GET THAT VALUE AND READY
It is not that apology ... this one takes micro..JYE-200M93 ..... CHROME THIS CARRIES TB1238BN AND STR S6707
THEN DO NOT PLACE 15K BECAUSE THAT IS NOT WHAT IS GOING THEN IT WOULD BE THE ONE WHO SAID VICTOR E TO THE START OF YOUR QUESTION GREETINGS
Your help helps me a lot anyone can be wrong ..... look at the one I think the titanic said it would never sink and without sinking he sank hehehehe a little joke
Ok victor there I do I will tell you shortly xq I have disarmed here at my table and tell you what solution there was
Ok ... I put a 1.8k and when I turned it on I opened 3 ctms of wide horizontal image ... and when I notice smoke comes out again in that 1.8k resistor and turned it off immediately before burn the horinzontal transistor
The ceramic capacitor c411 200v x 434 is very swollen I see if I have another equal to see what happens .... I will comment sldos ...
Well change that ceramic capacitor and put another one for 200v x 394 and go and see the whole image .... that was the cause so I thank you a lot for the time that I have removed