⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Tube TVs

Ken Brown Model KB 2 29SLIM B, Chassis PSW29UT - 3B stanby flashing

_el_CoNDoR_
hace 5 años
hace 5 años
Goodnight. I got a TV Ken Brown Model KB 2 29SLIM B, Chassis PSW29UT ---- 3B the stan-by LED lights up intermittently, the flyback hiccup is also heard I have no diagram .. suggestions are heard from now thanks.
Jesusemb2016
hace 5 años

Good companion checked the status of tsh?

Responder
luis tartaglia
hace 5 años

Hi. I think the same diagram you will not get. I will look for one for you.
You don't say anything you did to solve the fault. Review welding in general. Source - the vertical circuit. flyback And controls at a glance the source, output and vertical electronics that are not inflated. or doubtful

Responder
fferra
fferra
8.644
hace 5 años

a potato ; changes: c 542 / c552 / c572 logically respecting the value and even more 105º

Responder
miguel 86
miguel 86
2.160
hace 5 años

Hi, you gave the TV failure.

Responder
_el_CoNDoR_
hace 5 años

des welds in the two stages
vertical electrolytic capacitor failure.
that was it.
the dessoldaduras were not visible even with the magnifying glass
Just review everything just in case.

Responder
luis tartaglia
hace 5 años

You saw how you solved easily. Always does the same.
Salu2

Responder
luis tartaglia
hace 5 años
hace 5 años
http://www.mediafire.com/file/5k4rtm5k60nrc6s/
Javier Chavez C
hace 5 años
hace 5 años
To rule out that the problem arises either because of the source or its load (FBT and TSH) ....... Check the good condition of the filter capacitors of the auxiliary and + B sources in the secondary of the Chopper transformer Free the source of its actual load and place a spotlight (70w) as a provisional load of + B. In this way, check the stability and performance of the + B source, so that it then proceeds to place its actual load to observe changes or if the problem persists.
manolo karvalo
hace 5 años
hace 5 años
Hello Friend. check the source, resistors, zener diodes and rectifiers, and change the small filters and the opto coupler to new ones, and solve the choper and flayback pins and there after the choper there are some filters check them and check the diodes there . and check the tsh. It can be short and solved the pins of the ic. vertical. Cheers
_el_CoNDoR_
hace 5 años

crystallized welding fault invisible to the eyes and also with magnifying glass just review everything and start !!!
THANKS TO EVERYONE

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis