hi I have a philips tv model25pt544a / 77b
The flybacks I've seen are counted like this: seeing it from below, that is, from the pins; you will see that the pins form a horseshoe or semicircle, if the open part of the semicircle is down, then the pins are counted from left to right starting from the left end of the semicicle to the other end. Anyway it would be nice to know the model of that flyback.
It changes electrolytic video that is from pin 6 of the flyback, what could be this that you tell me
It is told as Jesus told you, but also guide you through the components that I named you: first diode 6485, then a resistor that jumped 3485 of 4.7 ohm and then there is electrolytic 2485 of 4'7 uF for 250v
where the license plate goes 2485 there is nothing no capacitor but I was walking like that
notice that it is 250v or more and another, check the polarity positive for the side that comes from the diode
Mario, the flybac pin is 5 and not 6 as I told you, but the elements are what I told you and in the 3485 electrolytic (4.7 uF x 250v) you should measure about 220v and following this line with the limes up to the platelet of the yoke socket you must get these 200v
I wanted to put: and following these cables to the platelet of the socket of the tube you should get these 200v to r 3340 (10 ohm), you must measure 200v of both sides of the resistor and then go to the integrated ampilifier of the 3 colors.
hello the reluctance 3340 I gave it and it does not give me any balor what colors are those that this resistance carries
hello if it was the resistance of 10 hom that was in the socket of the tube I changed it and weighed to walk without problems thanks to those who helped me
