Victor E

65.783

hace 5 años

and the source voltage is maintained when the tube insert is connected?

Marcelinomercado

109

hace 5 años

grace friend victor E if the + b stays clear the 180v is cut because the flayback stops working

Victor E

65.783

hace 5 años

I try to regulate the screen?

Marcelinomercado

109

hace 5 años

I also set it to zero, 355v, 400v at the maximum in any way it worked and I want to throw in the towel

Victor E

65.783

hace 5 años

No, you don't have to give up, I try to see if the screen voltage varies when the tube plate is disconnected? while the TV is on.

Marcelinomercado

109

hace 5 años

thank you friend for your support the tension is maintained on the screen of course if regulation varies at the moment I will change the vertical

alcides alvarez

407

hace 5 años

You checked if the diode 6318 of 8v2, is short, same as r3318 of 220 in the box that connects to the screen.

Marcelinomercado

109

hace 5 años

thanks friend alcides alvarez i will review tomorrow and i close the workshop thanks

Marcelinomercado

109

hace 5 años

thank you friend alcides alvarez for your success was the spare parts that you badly suggest a hug, a favor as I close this question thank you

alcides alvarez

407

hace 5 años

Friend, did you manage to fix the tv?

alcides alvarez

407

hace 5 años

To close, you must accept the solution proposal.

Marcelinomercado

109

hace 5 años

if the tv was repaired thanks to you alcides alvares for your suggestion and avictor and for your contributions also martha alicia

Victor E

65.783

hace 5 años

give a better solution to colleague Alcides Alvarez and close the post.

Marcelinomercado

109

hace 5 años

thanks friend for your contribution is the 47 / 160v but siestaria on the contrary it will not work this goes out when I install the card to the screen (undermine it)