⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Tube TVs

I have a 14-inch TV royal brand RT14CS11 model

rafael quintero
hace 5 años
hace 5 años
I HAVE A TELEVISOR BRAND ROYAL MODEL RT14CS11 WHEN I GIVE THE POWER BUTTON THE LEC LIGHT TITILA BUT IT MAKES A SOUND IN THE SOURCE OR TRANSFORMER BCK35077 OF TICTICTICTIC CAN NOT TELL ME WHAT IS THE CAUSE OF THE PROBLEM
neg2013
neg2013
14.048
hace 5 años

Good evening: First mention the chassis number to see if there are diagrams. Second some step you have taken.

Responder
rafael quintero
hace 5 años

CHASSIS JM 1499 L6565.PCB ONLY CHANGE THE VERTICAL AND CONTINUES WITH THE TICTICTIC

Responder
manolo karvalo
hace 5 años

Hello Friend. but before changing the ic. vertical had that tic tic or not

Responder
rafael quintero
hace 5 años

IF I HAD THAT TICTICTIC

Responder
manolo karvalo
hace 5 años

okay. friend. thank you bye you solved the fault. Greetings

Responder
rafael quintero
hace 5 años

VERY WELL THE IMFORMATION 100 PERCENT COMPLETE AND VERIDIC

Responder
Javier Chavez C
hace 5 años
hace 5 años
Unlink or isolate the TSH from the circuit, if the sound persists also unlink the FBT and place a bulb as a substitute load. In that way, perform stability test and performance of the + B source Check + B filter capacitors and source filters in both the primary and secondary stages.
Javier Chavez C
hace 5 años

Congratulations ....
Having completed the repair, it would be a good contribution to the forum, which I mentioned as a report, to the components that cause the problem due to its position code on the board (Ex: Q801, R125, C430).
Thank you.

Responder
luis tartaglia
hace 5 años

We will be in the sweet wait.

Responder
luis tartaglia
hace 5 años
hace 5 años
Hi. Your report is about. Commonly when doing that tictic is the TSH or some component related to it that is short and does not allow the TV to walk and make the source do that. So you know, control the TSH and environment. yoke, diodes and train. if it is in good condition, place a 200w bulb between the + by pin and the flyback pin. In ST mode you should not turn on it. Measure the voltage of + b. If you don't turn on the spotlight. From PW see and commented that it makes the focus. Turn on the maximum or dim or not on. Measure the voltage of + b at both ends of the bulb. always with good light and magnifying glass, general review of welds. I observed the state of components that are not overheated or inflated, such as electrolytic. Measure source and flyback output diodes.
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis