noblex tv 29tc668f be protected
friend. Just as I indicated, so in the diagram the capacitor 614 is 0.047uj of 630volt. so you have to put it with that number and letter
look in the chassis friend I can not find the number I noticed everywhere the only thing that says is this 1G4B10Y0030 friend tell me and tell me the resistance to leave the colors if that is ok
hello manolo see if the resistance that I put is yellow violet gold orange that is fine now the capacitor as I decipher my friend is a capacitor of polyester something like that because you know what happened that the TV came with in the R609 was the capacitor and in the C614 was the resistance friend that was intercabiated that is wrong not friend now I need that capacitor is if I know you told me but what number or letters you have to have
friend but what chassis is fixed there I tell you because I found those two diagrams by the tv model.
friend if the two resistance and capacitor elements are together the chassis is the lb5-a - but if they are separated from each other the chassis is the lb6-a I indicated because they are so in the diagram
look in the chassis friend I can not find the number I noticed everywhere the only thing that says is this 1G4B10Y0030 friend tell me and tell me the resistance to leave the colors if that is ok
friend look for the chassis number there will be the flayback from the bottom side or in the tube insert
Well the resistance is now the capacitor I was wearing was the 473J 630V that is good or bad I know you told me which one but I want to know if this capacitor is wrong
friend. if that number of the condesador had that same number put him-- I ask you if you were together because this is in the diagram lb5-a
friend if you have tv huezara plates. noblex there I found it and in the same position
if they go together friend then I leave this capacitor that is 473J 630V or I have to put the one you told me tell me if the one you have and the one you told me are equal or not friend
ok ok friend it happens that the tv came with the dead source had the fuse resistance burned 2 zener diodes in short the mosfet split in two and a burnt resistor I replaced everything I changed the optocoupler and the diode bridge but the tv now what I turn on the stanby led and when I turn it on it's like he wants to start the LED goes out but in 3 seconds he goes back to stanbye I don't know what he will be friends with because I measured everything and nothing even changes him horizontally and vertically and nothing keeps doing the same
friend. you changed the small filters there from the source if you haven't done so do it
if you have one, just change it later, the main one will change it too, but with both you do the same, also change the filter of + B and 5 more that go to the output of the choper but still the same I have in + B 113v in the filter + B I also have 113v in the main filter I have 334v I don't know I can't find the fault and I measure the diodes after the choper and they measure well I don't find anything else in bad condition nor does the friend fail
friend. and you checked the filters that are after the choper and solved the choper and flayback pins
If I solved all the complete the friend plate and the socket too and change all the filters at the exit of the friend choper it could be the flayback friend although I have 113v in + B I don't know what else I can do
friend makes a test first desolda the ic. If you do not turn on audio, do the same with the ic. vertical
ok friend are that and some other advice friend say if nothing happens with that tell me so I do tomorrow friend
friend. Solved the micro pins and solved the crystal pins that are there next to the micro jungle
yes friend can be but leave it as a last resort because you can try another new eprom without recording just as proof
You already know friend whenever you want an orientation in tvs trc repair. here we are why it is a community of I repair greetings