DAEWOO TELEVISION V and H deflection coil check
Televisor Daewoo DTQ-14V8SSFG
Televisor Daewoo DTQ-14V8SSFG
the solution was A TONTERY really what happened is that the 4 wires were altered almost reaching 4 points and were like "sulfated" from excessive heat and this altered their resistance "OF THE CABLE" because the CORRECT impedances were 15 ohms in the vertical and 4 ohms in the horizontal, but in EL SOCALO I average the altered values because of this cable which I DIDN'T SUSPECT I leave it as an anecdote so that if it happens to other colleagues they don't break their heads, in fact the TV was protected by fault of this "anomaly" this is the real solution and thank you all for your
dear nicomena is wrong it is COILS there is not measured its resistance "ohmic" is IMPEDANCE but I already solved it, it was simply nonsense the 4 wires were sulfated by excess heat and changed their resistance value, that if THE CABLE, because the vertical and horizontal coils are pure impedances you can ask another colleague or search the internet, greetings and thanks for your comment
Dear colleague: although it is true that q, are coils and q, when measured with an ohmmeter it can give about 2ohm ... but at the working frequency of about 15625kz the ohmic value of that coil is very different ... on the other hand a ohmetro does not detect if there is a short loop in a yoke ... but for a hor stage. or vertical a short loop is a direct short of the stage ... there are no differences ... this is my humble opinion ... greetings!
When measuring from the connection terminals of the YUGO .....
If only one of the fields is opened, if the impedance would increase, since the fields are generally connected in parallel.
In that sense my opinion goes.
The misunderstanding is for lack of argument on my part
My dear moderator
Two coils or 9.2 ohm fields connected in parallel would be approximately 4.5 ohm.
If one of the windings is opened, only the impedance of one of them would be read.
On that assumption, I base my opinion, since generally the impedance in the horizontal section of the yoke is less than 5 ohm.
Javier Chavez effectively the IMPEDANCE was altered and ignore comments from people who do not know about this saying that what is measured in the coils is "resistance" now the solution was A TONTERY really what happened is that the 4 wires were altered almost reaching 4 points and they were "sulphated" from excessive heat and this altered their resistance "OF THE CABLE" because the CORRECT impedances were 15 ohms in the vertical and 4 ohms in the horizontal, but in EL SOCALO I average the values that I said in my post anyway thank you very much