Adapt daewoo dtq-14n3fc tv board to Daewoo dtq-14v8ssfg
Televisor Daewoo DTQ-14N3FC
Televisor Daewoo DTQ-14N3FC
Hey, I don't have it, hand in hand, and in the workshop I don't have internet to be in touch from the wing directly, but what can you tell me?
Good morning, I don't know why it is necessary to adapt totally different plates, you must have your serious reasons imagine, usually Daewoo plates have a similar format, it is like adapting those Universal plates, you have to use Ingenio, if the The transplant plate slides well into the guides inside the TV cabinet. What remains then is to try to match the rear entrances or practice the necessary holes to fit, I repeat it is a matter of ingenuity ...
Well today I tried to place the board and I fit everything well even the connectors are all the same on this board but when I turned it on, something rang out and I turn off I think it broke a resistor I leave it I want so tomorrow I don't know if I have to change something I thought that everything would work because everything fit right now I don't know why that happened
Well today I tried to place the board and I fit everything well even the connectors are all the same on this board but when I turned it on, something rang out and I turn off I think it broke a resistor I leave it I want so tomorrow I don't know if I have to change something I thought that everything would work because everything fit right now I don't know why that happened
They are mishaps that my friend usually happens, do not be discouraged. Keep informed if you need any technical support.
Well today I tried to place the board and I fit everything well even the connectors are all the same on this board but when I turned it on, something rang out and I turn off I think it broke a resistor I leave it I want so tomorrow I don't know if I have to change something I thought that everything would work because everything fit right now I don't know why that happened
Will there be a need to change something else? That is, just change the complete clear plate with the trc plate
The yoke may be bad. We do not know which use.
Did you place the cable of anything from the tube that goes on the plate of the tube?
If I put everything in the morning I take a picture and I pass them on again I just change the complete plate with the cables and everything and the trc plate because they are very similar the yoke leave the same of the old TV only I replace the mentioned
Use the same yoke that the TV had, that is, do not change the yoke only plate with everything and the trc plate but nothing
Okay. Verify well all components that are not burned. Because if he felt noise something broke.
Anyway put a focus on SERIES between the + by the 200w flyback pin so try to avoid breaking something. When you are sure and give the ok remove the focus.
Well, my friend, I think it was clarified by several colleagues. Whether or not the plaque is another separate issue.
You must close this topic and if you want to open another one to solve the fault that is now presented.
The forum gives you thumbs to qualify. Let's use as you say.
Greetings.