⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Tube TVs

I need the diagram of the Samsung TV model cl29z40mq

Osman Ramos
hace 5 años
hace 5 años
I have a problem with the Samsung TV model cl 29z40mq that did not open the image completely horizontally and then turned off and did not turn on realizing it brings the damaged flyback but I need the diagram ... I would greatly appreciate your collaboration
manolo karvalo
hace 5 años

friend. If you have damaged the flayback you have to change it for another that is its respective replacement or the original, and indicate the number of the TV chassis.

Responder
Javier Chavez C
hace 5 años
hace 5 años
Diagram here https://www.electronica-pt.com/esquema/tv/samsung-esquemas-tv/samsung-cl29z40mq-chassis-k16a(n)-m-14544/
Osman Ramos
hace 5 años

Friend before closing the post and giving a solution, could you tell me some equivalent to the flyback since I do not find it the same because I need the letter G at the end of what they are offering me

Responder
Javier Chavez C
hace 5 años

What is the original series?

Responder
Javier Chavez C
hace 5 años

The last letters are improvements or changes with respect to the previous design.
Maybe the one they offer is compatible

Responder
Osman Ramos
hace 5 años

The original is the fuh29a001g and the one they offer me is fuh29a001 without the g

Responder
Javier Chavez C
hace 5 años

Here is the connection of the pins (PINOUT) of the FUH29001 If it is compatible with the original, you can try ..
https://www.yoreparo.com/es/tv/televisores/tubo/preguntas/1111342/datos-fuh29a001

Responder
Osman Ramos
hace 5 años

Notice friend that the TV in question has a FUH29A001V on but before it was damaged it did not fill the entire image of the sides as if it had a cushion effect

Responder
Javier Chavez C
hace 5 años

The cushion effect is produced by damaged components in the East-West (EW) correction stage including components in the horizontal output stage and circuit around the yoke in its horizontal section.
Once the stage has been verified and the symptom persists, enter the service MENU and reset these parameters.

Responder
Osman Ramos
hace 5 años

I will try, then, friend, thank you for everything ... I will close this post and then, otherwise, I open another question but for the moment it is solved, it is with the diagram thank you very much

Responder
Javier Chavez C
hace 5 años

Until a next opportunity

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis