hello colleague :: I have to measure the C406 and see if it is leaking or is short ... if it is going to replace it, I must put a new one of the same capacity and voltage value ... 0.027mf x 400v ... of polyester ... .If that is OK, measure the source voltage and see if the + b remains regulated at 110v at C814-220mfx160v and C835 at 47mfx160v ... if the + b does not regulate well at 110v, change the C814 to 220mfx160v . and see results ... for that you have to remove the TSH from the plate and connect a 60-75w filament lamp between the positive of the C814 and mass and see if the + b remains regulated in the 110v ... TSH can be damaged by several other causes ... + b passed -... fli-bak- damaged -... etc etc ... you must measure diodes D406-D407- and see if there are any leaks or in short in the hor stage, ... check the C414 of 15nf x1600v and see if it has no leaks or is short ... if all those components are fine, check the fli-bak and yoke ... see if they are in good condition been ... ok ... greetings !!!