




hello friend: if you have knowledge in repairing this type of tvs ... comment q, review and measurements do echo to try to uvicar the fault ... ok ... greetings!
Hello friend, I tell you that it is the first time that I see that fault, I do not know where to comment, all I did was move the potentiometer of the Flyback screen, and check some filters at the stage of it. I saw everything normal in the filters and improved a little when I moved the screen, but it really did not happen, since I have not had the experience with that fault, thanks.
if it is the mc-059C chassis ... the test of the screen is to turn the potentiometer clockwise until q, lines of delay appear ... there and you turn it back until q, they disappear ... if with that test no If the kite effect is gone, it can be an exhausted tube ... in that case, what you can try is to bridge the FR401 of 2.2ohm and see if it improves the image ... these tests are the most common to verify if it is tube deficiencies .... this would be if you have knowledge to do these tests ... comment results ...
I apologize for the delay in responding, I had technical problems with the Internet and communication, but here I am very grateful to everyone. To summarize the technical solution, I took the plate of the cathode ray tube and solved the transistors and other things that I saw with cold welding, when I turned on the TV it looked much better and I controlled the brightness and contrast by removing the kite tail. Very grateful to everyone for their comments.