⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
LCD TVs - LED
How do I start philips tv source 42pfl3403?
1.651
hace 5 años
hace 5 años
In CN6, it establishes a bridge between Standby and 3V3 ST. Use a 1K Ohm resistor in it.
After doing so, verify the presence of outgoing voltages (12V), taking into account that if there is no presence of connected load, the voltage will be somewhat above 12V.
Greetings from Uruguay
264
hace 5 años
Hi. Thanks for now.
I did that but the 12v did not appear
But I was seeing that when doing that bridge, RE1 is activated if I am not mistaken.
Then I jumped RE1 and the 12v + and the 12 v - appeared
It is seen that the problem is in the standby source despite the fact that 3.3v and 2.5v reach the connector.
Well then I value your answer because I think it is correct.
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad