⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
LCD TVs - LED
Samsung UN50FH5303 very high voltage on LED strips BN44-00668A board
hace 5 años
hace 5 años
Good afternoon everyone and I hope you have a very happy year !!!
I got this samsung led tv to repair with several burned leds but notice that after replacing them the board delivers about 3.7 [/size[=15.6pxvoltios[size=120] to each led and heats up the you throw and modified several source plates to reduce them [/size[=15.6pxvoltaje[size=120] but with this plate I can't hit anyone who knows it or has the diagram me [/size[=15.6pxpodria[size=120] lend a hand? thank you very much!
hace 5 años
hace 5 años
Hi Leonardor, you can lower the voltage that feeds the LEDs as follows: 1) Enter the service (or user) menu. In the image screen give ok or enter 2) with the down arrow you are located in BACKLIGHT or Back Light or backlight and give ok or enter. 3) If you have scale from 0 to 20 with left arrow. you lower it to 12 or 15 (and you measure how the voltage drops) If it is in percentage it lowers it to 70, 60 or 50% depending on the voltage drop, then press ok or find out. Of course a little will lose contrast, but then you can place yourself in cont. and brightness and you regulate it at ease)
hace 5 años
This can also be done on the source plate. You look for the negative line (- LED) and following the track you get to a mosfet, leg 3 of this is the one that goes to mass through an R or several in parallel. If it is only one, you must change it for one of somewhat greater resistance and try, if they are several, as they are in parallel you can take one or two resistors which increases the value of the total R. Other times the LED line - does not go to a mosfet but to an integrated one that has the built-in mosfet. In this case the leg of the integrated one that goes to ground has 1 or more r in // (vary said R)
hace 5 años
Very good leonardor, it will be until next time. I tell you in case you do not know how this forum works that when solving the problem you must click on the proposed Solution of who else helped you to solve it. In this case as only my proposal is, a click on mine, this way this post is closed as solved and can be served by another colleague with the same problem. Thanks greetings.
hace 5 años
if as you say you want to rate the click you must do it above in my first comment where it says: 1 (in red) and then proposed solution. regards
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad