Ruben Costilla

13

hace 5 años

already disconnect the key panel and if I touch any key on the remote control it changes channels and does not stop

Ruben Costilla

13

hace 5 años

I already solved the problem, good medium, I solved it, but it works
Checking the key panel I see that it has two lines comparing a tester I discover that one of the lines
had a lower resistance than the other is KEY 2 that controls ch- v- and source
Following the form I arrive at the micro
The solution I gave him was to take a 10-hom resistor marked with the number R416. This resistance goes to 3.3 v and disconnects it and is perfect but does not control V-ch- or source with the panel but with the control if

Fernando Barillas Corona

2.638

hace 5 años

Well, it was good that you solved it, if you like to value the assistance although it was not quite accurate, it is up to your consideration, but good tip for the companions that of the resistance saves headaches, although it is not 100% but it works, luck and greetings.

Ruben Costilla

13

hace 5 años

the qualification for Fernando Bari was because I guide him to look for the panel