⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
LCD TVs - LED

samsung tv pl51d450a2d does not turn on

bryan gomez
hace 5 años
hace 5 años
Hello, good day to everyone here annoying I have this 51 plasma tv which does not turn on since it has the fuse open and proceeded to check it source and has the mosfet in short and two burnt and non-severe resistors the registration number rs806 and rs809 and open the ds821 open the mosfet qs802 and qs801 and would ask you to provide the diagram of this source is the bn44-00443a otracosameencontre enmi undone an identical source but pl42d450 I put it on and it started I think that I can affect it because of the size of the screen since turning it on as it needed to illuminate pixels and and in a few seconds it took off and opened it well that they advise me to I leave or repair the other Beforehand thank you very much
gilar
gilar
6.594
hace 5 años
hace 5 años
You just have to adjust the VA and VS voltages, on the panel there is a label and the voltages are indicated, at the source locate the presets ... greetings
bryan gomez
hace 5 años

check and I will do it and comment thanks

Responder
bryan gomez
hace 5 años

I already check in the panel that:
vs are 207v
it goes 58v
I have in vs 210.8v
in va 57.7v
I leave it or I leave it exactly

Responder
gilar
gilar
6.594
hace 5 años

it has to be exact, let the screen work for 5 minutes and then proceed to the settings

Responder
bryan gomez
hace 5 años

already calibrate the voltage remain 207v and 58v the
I'm going to stop working and comment again

Responder
gilar
gilar
6.594
hace 5 años

Look closely at the image, sometimes it presents a bit of granulation in the image, if not, that screen is ready ... greetings

Responder
bryan gomez
hace 5 años

I already noticed that that says granulation does it to me sometimes when I connect it to the outlet and activate the relay but when I turn it on it turns on well
the granulation because it made it happen

Responder
gilar
gilar
6.594
hace 5 años

Increase VS voltage slightly more

Responder
bryan gomez
hace 5 años

Now increase the voltage but stay the same for a moment

Responder
gilar
gilar
6.594
hace 5 años

On the Y-SUS card it locates the voltage of 15 or it can be up to 19 volts, that voltage is filtered by an electrolytic that sometimes due to being low in its "ESR" causes that defect change it

Responder
bryan gomez
hace 5 años

Thank you very much for your contribution and your help was the solution change the filter and work well

Responder
gilar
gilar
6.594
hace 5 años

How good you can close the subject ... greetings

Responder

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis