⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
LCD TVs - LED
Pioneer PLE 32 control does not work
13.721
hace 5 años
hace 5 años
Hopla, iguel, welcome, that macana, you must have installed the wrong software ...
I'm going to tell you to visit a site and tell Martin the administrator on my part what happened to you, I play that with the firmware of that page you get it forward
it is installed with a pendrive with the TV off
https://www.mundotecnico.info/viewtopic.php?t=92
If you answer, I give you my Like of Luck for solutions but I hope for yours;)
If you ask a question in the forum, always answer it, the colleagues who answer you spend your time and knowledge with the will to help you, if you are grateful, choose the best answer and give a Like to those who participated.
Thank you for collaborating in the forum and Success with your repair
2.160
hace 5 años
He was left with the logo branded, until that moment he would take control, then when he updated he went on television and the control did not, then he went normal, he delivered it not a month ago, he is not in control, I tried with a new control he does not walk, so it is my doubt if did not update well or receiver failure,
13.721
hace 5 años
I think the most drinkable
It has a power pin, it can be 5 or 3.3 volts
has a dough pin and
It has a pulse output pin, this at rest is at the same voltage as the source, if it is less voltage is bad. When you receive a signal from the remote, the voltage drops, with an oscilloscope you can see the pulses
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad