Haier TV model L26F6 does not turn on
If you already check the 12 volts when you give it to turn on and the 24 volts also when it goes from stambay to ignition mode it has its voltages (12 v 24 v 5.3v and 3.3 see) but does not give image or sound signals do not turn on the led
if you have the voltages when going from stanbay to on you have the 12 v the 24 v the 5.3 see and the 3.3 see but do not turn on or see image or sound
the voltage of 5.3 is present while the tv is in stanbay mode once it has been switched on, the voltages of 12, 24, and 3.3 volts appear, the main card is connected to the source
the vocations are present once I give it to turn on the tv 12, 24, 3.3 and the voltage of 5.3 than that of the stanbay but it does not give image or audio or the lamps turn on
I did what you suggested to me to take off the cable lvds of the T com card and the lamps do not turn on the stanbay 5.3 voltages and the other voltages are maintained once I give it to turn on 12, 24, 3.3 volts probe the power source by just bridging it and it gives me the voltages of 12, 24 3.3 and 5.3 volts the same voltages as when connected to the main card
I am going to check the lamps as you say I do not have to send you photos of the source the model is L26F6 if I notice that the Main card the micro processor heats up I do not know if that heating is normal
In the questions related to the subject there is a photo of the source of the companion Jean electronic of this tv model
I don't have that number on the board if you have WhatsApp I can send you the photo of the Main board and the source
friend plug to suggest answer you saw the source this does not carry any green card fuse is a resistor that is close to the heat sink
friend plug that you suggest me about the fuse check it is ok I reviewed the solder to the source follows the fault if I notice that the micro heats up more than normal and after a while the TV goes to stambay protecting itself
Friend plug thanks for the advice a friend lent me a power supply card and the TV on I have it tested and tell the client if it is convenient to mount that card that is new the other card has apparently bad investors which are complicated to get on these tv
my corduroy shows him the television working that his client when he sees it is not going to deny what you are going to charge him and he will be happy and you already know that the problem is the ballast later I teach you how to incentivate the protection just to try and you can close the post and my name who assisted you "JOSE MURILLO2014" greetings
