Panasonic TV problems TC-P42C2X
Televisor Panasonic TC-P42C2
Televisor Panasonic TC-P42C2
you will have to look at what two connectors the bridges have to do, because the truth is that I don't know this board and it can be a false load and then unlike the led ... two bridges have to be made between normally-connected ps-on and ground pins and on the other connector with vson and a 47k resistor and the 5.5v pin
Good afternoon, panasonic plasma when not activating the relex is because of the 3.3v that is generated back to the source and therefore does not activate the relay just be connected to the AC line, therefore and by experience the pcb main board It's bad and that's the evil of that model.
Miguel Soto, Panasonic of Venezuela.
miguelsantares@yahoo.com
monico.soto@datahosting.net.ve
And what about the 15 volts of stambay that the source must give and does not give them, coincidentally those 3.3 volt sources on the main pc, feed on the 15 volts of stambay ????
This TV is not a LED TV, it is a plasma TV and the source is SanKen PSC10312K M ,,
I don't know how to activate that source
All sources are activated the same, please see if you understand better https://www.youtube.com/watch?v=mRtTUrO3RiM
I need some scheme of a sanken PSC10312 km source, or some video of repoaracion of this type of source, I only have 5 volts of stambay, I do not have the 15 volts