Hello everyone, the mentioned TV has the following behavior: When turning on, the display is in refresh mode (colors, red, green, blue, cyclic etc). It has audio, I put cable and can be heard when one changes channels normally. The following was tested: another main was tested, it presents the same problem (therefore it is not in agign mode). It was cleaned and continuity was checked in the man / t flex with, and the 2 flex tcon / display. The tcon lights both LEDs. Tensions were checked in it, all OK. I would like to know if someone was in the same situation, since I am about to ask the TCON to rule out. regards

AGIN-MODE (autonomous mode) does not necessarily come into operation if activated from service mode, it is enough that the signal pair CLK + and - are not present and automatically comes into operation, what causes this defect? the first, it must be verified that the cables are not open, the second is that this signal is generated by the micro from the main board, and the last one is entering signals or frequencies that are generated from the power source, which it is done is to isolate cable from lvds and t-con, and even to the same power source, in very extreme cases the AGIN-MODE signal is canceled by cutting that signal in the t-con ... greetings