Main Samsung LN32C550 burned out by Main Samsung Ln32C450
Televisor Samsung LN32C450
Televisor Samsung LN32C450
Hello, your report is very good, thanks. I should have seen it before I started. According to the display you use, the board is different. The easiest was the change of connector, it was very complicated for me the change of the R that I only see three, near the lvds connector and the doubt of whether or not the 4 diodes that the C550 has and not the C 450 When placing them, the screen is black and without blanking. the voltages of 12 and 5 volts are fine but this source if you disconnect from the main turns it on if the 450 volts are on the filter, it seems that there is a short film that I can't find. very difficult to follow Sdos
Friend you must first make the main work, verify its power and that it corresponds to the voltages provided by the source, when this garment you will realize because they turn on the LEDs and you will see the light that comes out of the optical audio, it is then that you must worry about the adaptation of the display, when you achieve this comment that the other is simpler, it is always possible, I have adapted main LCD TV to last generation display and vice versa, but first you have to get the main to go. Regards
OK Thank you. I did some adaptation of main and T with and I stayed well, however, from full hd to hd the others provided that the tensions worked well, this board comes for both adaptations but there are bridges to change and there comes the problem. > The best thing is how it would be said after the main c450 works because it has the same source, it is to work as a decision in the connection of the display, as regards the lvds inputs. REGARDS
