⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta.
🔥 Aprovechar oferta ahora 🔥
LCD TVs - LED
Panasonic TC 32A400 TV fault
hace 5 años
hace 5 años
Hello
I have a Panasonic TC 32A400 TV which standby LED turns on and off 3 times according to error code and breaks in any of the sub-sources.
I check and confirm that the sub-sources are activated and protected. Since the signal of SUB ON falls and checked resistance and diodes in this area and I see nothing wrong.
If you can advise me, I thank you
Thank you.
hace 5 años
Sanfalla tell me if it is bridging with a 1K resistor I entered 5.3v of standby and power ON.
hace 5 años
Ok I tell you this source of power starts by connecting the resistance to the SUB ON pin so it didn't start me before.
The test was performed again and the voltages remained stable. The fault would already pass in the main.
hace 5 años
Well I share the experience after doing tests at the source and following the error of failures in the service manual and the help in the forum all pointed to the Main which was changed but followed the error.
Finally I decided to review everything and not focus only on the fault marked by the manual. I check the LEDS and surprise 3 LEDS out of service maintenance and SOLUTION.
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis
Ad