⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Decoders

Deco l12 signal failure

jesus201
jesus201
jesus201
347
hace 5 años
hace 5 años
Good evening, dear colleagues in this occasion, I will talk to you because I have a signal failure in the 12th of full bale I have the correct 13 and 18 volts but it does not fill the signal bar if any m could help I would appreciate it
Comentar
MoisésSánchez
hace 5 años
hace 5 años
Good night, that fault is given to you by the microprocessor. you must reflow it with a little liquid flux. I tell you from my own experience. I hope it helps you
Comentar
jesus201
jesus201
jesus201
347
hace 5 años

Friend if it is solved only with reflow and you have already managed to get that fault

Responder
MoisésSánchez
hace 5 años

If I have taken it out, but remember that reflow is not a safe method since it will heat the microprocessor, the device may not turn it on anymore, you should explain to the customer what kind of risk the device is undergoing!

Responder
MoisésSánchez
hace 5 años

After refilling, I put a fan cooler to dissipate the heat produced by the microprocessor and extend the life of the microprocessor, but at some point it will fail again

Responder
Carlos José Borges
hace 5 años
hace 5 años
Correct is the risk that the equipment does not turn on more but if failures are solved but if the processor is still overheated the safest is that the fault returns
Comentar
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis