⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Welders

Plasma cutmaster 42, the alternating LED flashes and does not emit an

iron__pablo
iron__pablo
1.598
hace 5 años
hace 5 años
From the thermal dynamics brand. The pressure switch which works correctly is tested. It was also tested on different outlets, but still with the same symptom. It starts all normal but when the torch is triggered, the alternating LED starts to flash. The power part, the igbt mark a normal resistance, that is, they are not short. Does anyone have any information about this machine? From already thank you very much! 20200116_094126.jpg [3.23MB]
Pilaraprendiz
hace 5 años
hace 5 años
You have low voltage Confirm the voltage selection switch on the back of the machine. It is embedded in the cover and only a small circle appears. Confirm if the main contactor enters after about 5 seconds after turning on the machine. If all is well and the supply voltage is correct, then you have a problem with the power modules. Here you have all the info that is available: Cutmaster 52.pdf [6.93mb] I don't know if it charged well, my phone was alarmed during the process. However, the information is available on the network as "Cutmaster 52 service manual".
iron__pablo
iron__pablo
1.598
hace 5 años

Thank you very much for the information! I will check according to what you tell me. A hug!

Responder
iron__pablo
iron__pablo
1.598
hace 5 años
hace 5 años
The problem was the torch parts. They did not look scorched or anything but, according to the service manual of the machine, those parts had to be replaced. They were changed and cut. Thank you!

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.25
(8)

Reparación de Placa Main TV LED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 40 USD
$ 20 USD
4.73
(22)

Curso Reparación de Fuentes Conmutadas de PC y Equipos Electrónicos

Maximiliano Resch
$ 40 USD
$ 20 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis