⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Alarms

Cancel phone line fault in dsc 585

Pablo Diez5

hace 5 años

Good morning, I have the DSC 585 alarm, connect everything well, and it gives me a telephone line error, therefore it does not let me activate it since the keyboard is beeping every 10 seconds. As I do to eliminate the error this since I do not have a telephone line (nor am I interested in having it) and I do not have a GSM module because they are very expensive. I await some response since I am becoming changos with this. Cell deleted Edited: Do not use capital letters, it is equivalent to shouting.

Comentar



andresvazquez11

462

hace 5 años



hace 5 años

hello good afternoon, the alarm with the telephone line failure will allow you to activate, if it does not allow you to activate at this moment the problem is different. To eliminate the telephone line fault as they told you, you must enter the programming (* 8 5555) 015 and turn off bit 7 which is the telephone line control regards Andrew

Comentar

Pablo Diez5

hace 5 años

Thanks, I could get the error, the only one left is the 1 that in theory is the battery, I have it connected but it looks like it died, is there any way to get that error and continue without battery until I buy one?



Responder

andresvazquez11

462

hace 5 años

Hello Pablo good day, when it indicates fault 1 you have to press the 1 again to verify what the fault is, it can be the battery as you indicate or it can be the siren or some other things it depends on which light you turn on after touching the 1, it depends from this the steps to follow to eliminate or mask the fault
regards
Andrew



Responder

pachipac

hace 5 años

in the central pc1616 it is done as follows, enter session 015 and turn off bit 7 ... I think it's the same programming

Comentar

Pablo Diez5

hace 5 años

Sorry for the question, how do I get into that?



Responder

redo

7.086

hace 5 años

within fault 1 you must press key 1 again to see which subfallo marks you, its battery and as long as you do not change it you can remove the keyboard sound by pressing and holding the asterisk key (*) until the sound scares



Responder