I recently disassembled the dashboard of my car, and in the process I found a frightening cable arrangement. During the process I had to disconnect the car alarm (since its installation was disgusting with a lot of insulating tape, badly attached cables etc. Now I would like someone to explain how to reconnect it again (I want to make the new electrical installation) The main connector of the module (through which the alarm was connected) has written on the board and for each pin of the connector the following legends: - TRUNK - TG + - TG- - SIREN - LAMP - ARME - ACC - GND - 12V In that order I need someone to tell me what each pin is connected to (except 12v and GND) and from there I manage. I appreciate any help. By the way, according to the remote control the alarm is a megavision USA and the main module board says am600s Rev: 6.