⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Alarms

Schedule Alarm X-28 M20

Agustin Meler
hace 6 años
hace 6 años
Hello, after many problems with the alarm I took her to the official house to repair and at the time of uninstalling I asked the technician to verify that the installation is good and the only thing she did was to put the positive of the alarm after the motorcycle fuse and I change the position of the orange cable (previously it was in the green cable with yellow stripe, which I understand is the positive cable of the brake light and scratch) the replacement of place by the yellow cable with red if I am not mistaken that according to the It was from the neutral potion. The problem is the following one is already repaired and installed (I only had to connect the card that simply has a single position so there was no way to make a final mistake since all the work was done) Now the problem that the controls both have the green light when pressing and apart configure it in automatic mode (8 5 1) and everything is perfect but today I realized when I forgot the control of presence that this is not working with this function only active and deactivate how do I solve it ?
Adrian Positron
hace 6 años
hace 6 años
Hi . In order for VI to work, you have to respect your alarm and reprogram the controls. The presence is programmed keeping the control pressed. When you make the beep, don't release the button until you repeat it. About 5 seconds Look at the manual for programming the controls ... enter programming and keep the touch pressed until you check that I delete all the controls.
Agustin Meler
hace 6 años

Thank you very much on the key, I did the following in case anyone has the same dilemma.
1) Deactivate the alarm.
2) before the 10 seconds passed I made 5 consecutive presses.
3) Press another 8 times after the signal (it is quite evident) and made another one after the last presses. There I pressed again 8 more times in a row and made another signal again.
4) I kept the touch pressed until he made another signal.
I understand that this process is to erase controls in case one needs it.
Then set the controls as you said and walked a show. Thank you

Responder
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.73
(22)

Curso Reparación de Fuentes Conmutadas de PC y Equipos Electrónicos

Maximiliano Resch
$ 40 USD
$ 20 USD
4.87
(15)

Curso Diseño de Amplificadores de Máxima Fidelidad

Maximiliano Resch
$ 29 USD
$ 13 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis