⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Refrigerators

Doubt for 1 / 5HP compressor change

nachito_le2099
hace 5 años
hace 5 años
Hello everyone, I am about to make an adaptation with a GAFA freezer that has a 1 / 5HP engine with 4 ways like the one you will see in the photo. The adaptation I am going to make is because the motor compressor they sold me has only 2 ways. Step to comment: In the original compressor that we will call "via 1" it is suction, the "via 2" leaves, passes through the upper half of the condenser and returns through the "via 3" to the compressor, returns through the "via 4 "towards the bottom half of the condenser returning and connecting to the filter, then capillary, evaporator and return to" via 1 ". You will see one marked "5" in the photo that is where you would go to the valve for assistance. My adaptation will be to connect the "via 2" with the "via 3" by welding a section of copper pipe. Now if my query is my logic correct? Has anyone already done this job? [url=https://preview.ibb.co/mWeZF6/Whats_App_Image_2017_11_25_at_17_22_57.jpg] https://preview.ibb.co/mWeZF6/Whats_App_Image_2017_11_25_at_17_22_57.jpg" alt="" />
apiconauta
apiconauta
3.917
hace 5 años
hace 5 años
Hello Nachito: The two pipes that are in the lower part of the motocompressor are only a curl inside the crankcase of the same, what you have to join are the tips of those two pipes that you take out, in your case it would be N ° 3 and N ° 4. The other three are suction, discharge and service. Luckily, discuss your results aceite.jpg Heater [13.94kb]
nachito_le2099
hace 5 años

Precisely that was my doubt if the pipe 3 when entering takes pressure again or not. Thanks for your prompt response

Responder
cesar augusto cerna
hace 5 años
hace 5 años
The solution is already well, there are 5-tube oil-cooled and static or 3-tube air-cooled compressors.
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.25
(8)

Reparación de Placa Main TV LED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 40 USD
$ 20 USD
4.71
(7)

Curso TV OLED y QLED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 29 USD
$ 10 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis