Liquid trap in a frezzer
HELLO FRIEND I THANK YOU VERY MUCH FOR THE ANSWER AS YOU LEARNED THE TECHNIQUE AND THE CHANGES IN THE FRUITS REMAINING WELL.
A CONSULTATION MORE THAN THE CAPILLAR I AM GOING TO USE HOW MANY CMTS TO INSIDE THE PIPE IT IS POSSIBLE TO PUT IT IN? THE 1/4 PIPE RIGHTS VERTICALLY FROM THE FLAT UP TO THE TOP OF THE FREZER THE NON-AFFECTED GRAVITY ON THE CAPILLAR I MEAN BY ACCUMULATION OIL THAT COULD BE GIVEN IN THE PIP I WAIT UNDERSTANDED I WILL SEE IF I CAN OPEN ANOTHER QUESTION BY MAKING A GRAPHIC. MANY THANKS FRIEND.
I understand perfectly it is not necessary to open another related question, the ideal would be to start from above to create a waterfall effect, the capillary can penetrate about 3 or 4 centimeters. Luck S @ lu2. Thank you for your feedback.
BEGIN FROM ABOVE? TO SEE IF I UNDERSTAND YOU TELL ME THAT INSTEAD OF PUTTING THE CAPILLAR IN THE PIPE THAT COMES OUT OF THE FREEZER I LEFT THE PIPE INSIDE THE MACHINE. CAPILAR INSIDE THE MACHINE AND ENTER THE PIPE. WOULD IT BE LIKE THIS? HOW WOULD THE CASCADE EFFECT COULD GRAPH IT AS IT WOULD LIKE IT?
It is the same as how he is doing capillary is out of the furniture of the equipment for future repairs, but the pipe, it goes up to the top and then goes down. S @ lu2
I WILL COME FROM THE FOLLOWING FORM ONLY TELL ME IF IT IS CORRECT. THE 1/4 PIPE COMES VERTICALLY OUT OF THE FURNITURE I WILL ENTER THE CAPILLAR IN THE PIPE OF 1/4 MORE OR LESS THAN A METER THAT IS THE LENGTH UP TO WHERE THE CURVE AND THE PIPE OF 1/4 IS HORIZONTAL AND THERE IS THE CAPILAR PUSHED ABOUT 4 MORE AND READY. IS IT RIGHT?
With the capillary insert 4 centimeters from the beginning of the 1/4 tube, outside the equipment would be enough. S @ lu2.
Reparaciones similares solucionadas
¡Aprende a reparar con estos cursos YoReparo!
