⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Refrigerators

My refrigerator does not start

Claudio18
hace 5 años
hace 5 años
Hello my people .... I consult the following it turns out that I have a refrigerator with two zenit side doors frezzer are those that are also connected to the water pipe and without opening the refrigerator you will be served water or ice .... well the refrigerator does not start I took out the relay and thermal capacitor and put a relay and a direct thermal to the motor with a cable and started the engine just fine and consumed 2.5 am that is a test that is to rule out motor problem .... now I connect everything and everything new as it should be and does not start ..... will the thermostat be ??? I did not want to touch it since this thermostat does not rotate in a circle but in a vertical and I never saw them .... thanks for your time and rich wisdom
Fermin 007
Fermin 007
57.307
hace 5 años
hace 5 años
If you are sure it is with thermostat possibly it's the timer, you have to locate it then turn it and see if it already turns on, if you could upload an image, help would be better, greetings
Claudio18
hace 5 años

Thanks for your time...
If I turn the timer but it didn't turn on either ...

Responder
Claudio18
hace 5 años

Thanks friend .... end of the diagnosis was a timer that burned and was very well hidden ... thanks

Responder
Fermin 007
Fermin 007
57.307
hace 5 años

How well dear Claudio, thank you for clarifying
That was finally a timer that burned, regards
and congratulations that you solved.

Responder
SOBERANES
hace 5 años
hace 5 años
CHECK IF THERE IS VOLTAGE IN THE RELAY AND THERMAL INPUT IF THERE IS A COMPRESSOR WELL (RESISTANCE BETWEEN COILS, GROUND TERMINALS OR GROUND INDUCTION) IF THERE IS NO VOLTAGE CHECK THE TIMER AND TEMPERATURE CONTROL IS VERY PROBABLE TO HAVE A CARD IF WHEN YOU STARTED IT SOUND A LOT, THE MOST SAFE IS THAT THE COMPRESSOR HAS A MECHANICAL PROBLEM AND THAT'S WHY IT IS COST TO START ANOTHER CAUSE IS THE LOW VOLTAGE OR VOLTAGE DOWN THIS IS DUE TO A BAD INSTALLATION OR PROBLEMS IN THE ELECTRICITY COMPANY
Claudio18
hace 5 años

Grasias for your time ..... I did not take into account the detail of checking the entrance to the relay as it turned on the light inside .... the compressor sounded annoying but it associated it with the vibrations since it is large it must be 3 / 4 or more ... under open voltage but not at that time ... I also noticed that in a frezzer from the same address did not start probe changing thermal relay and nothing ... change the thermostat and left walking ... It will be . They burned both thermostat from low voltage ...

Responder
pablo lamas
pablo lamas
2.661
hace 5 años
hace 5 años
Hello, check the thermostat, bridge the two lines and if it starts, you have already found the fault, and you only have to change it, regards.
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.93
(14)

Curso Reparación de Equipos de Audio de Alta Fidelidad

Maximiliano Resch
$ 60 USD
$ 20 USD
4.73
(22)

Curso Reparación de Fuentes Conmutadas de PC y Equipos Electrónicos

Maximiliano Resch
$ 40 USD
$ 20 USD
4.87
(15)

Curso Diseño de Amplificadores de Máxima Fidelidad

Maximiliano Resch
$ 29 USD
$ 13 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis