Hi People, I am repairing a two-door wrm36d wirlpool refrigerator, no frost. The case is that it does not turn on the compressor. It has an electronic platelet but before deciding to buy a new platelet I would like to ask if someone can tell me the value in ohms of the temperature sensor (today I did not mark anything), I measured in defrost temperature sensor gave me approx. 4 / 5k ohms and the fuse apparently has continuity. I measured and tested the compressor manually and it works properly and cools. The forcer works after 20/30 seconds of being plugged in and does not stop when opening the door of the frízer. It has no variable thermostat, the circulation air ducts are free. When I plug in the refrigerator, after a few seconds the platelet relay sticks and takes off but does not send voltage to the compressor. Before deciding what the platelet is, I would like to ask if I am forgetting to control something or if the values of the three sensors are correct. Thank you in advance for your comments. Best regards !

If it does not turn on, change the relay. but if with the new components just click. Let me tell you that your compressor was tied. That problem happens when there is a varicose voltage and we leave it for a long time. Luck always recommends a voltage protector.