Good day, thanks for the help. My doubt is if the freezer of my refrigerator is working well. The problem began, when my wife told me that it was not cooling well, after she moved the refrigerator to find something that fell behind her. I completely disassembled it, cleaned it and defrosted the ice that had gathered at the base. I have it on and empty since yesterday. From what I monitored, it goes from -10 ° C to -25 ° C precisely, starts the engine at -10 and turns it off at -25 continuously. The refrigerator is Siam of the economic, I think a single engine. It has two years of use. The bottom of common cooling, works perfect (1 ° C-4 ° C) Attached model and the times I measured. Thank you so much for helping me. Model: Fridge Siam Hsi-ft13bd 355lts Bca Neo Frost C / dispenser Temperature measurements (temperature + time): -25.6 ° C (17: 30hs) deactivated motor -23.7 ° C (17: 13hs) -20.5 ° C (17: 30hs) -16 ° C (18: 00hs) -13 ° C (18: 25hs) -11 ° C (18: 40hs ) -10.2 ° C (18: 45hs) motor activated -23 ° C (19:30) -24.5 ° C (19:50) -25.5 ° C (20:15) deactivated engine Thank you very much for helping me

If it is with a thermostat, this attachment is not exact, but as I see the time and temperature shots are working within the range, and after the times and temperatures are regularized they will be more or less similar, the thermostat could be a little bit uncalibrated , but for me it is working very well, now I don't know if you were moving the thermostat scales, but it is best not to move it and leave it for example in a medium term say in three or four and no longer move it from there, ahh se It happened to tell you, never move a refrigerator when it is working, because it can be clogged, if they are going to move it, it is disconnected and then wait a few minutes, 10 or so and then it moves, never load it sideways, drag it evenly and slowly greetings

Good afternoon, I thought you had responded at the time, but no. The refrigerator did the same problem again. By chance, the technician of the air conditioner told me that it was sure that the hole was covered with frezzer water drain, for that reason he collected ice and stopped cooling. Said and done, I uncovered it with a wire and holy solution, it chills that is scary !!!! Thank you all for the ideas !!!!!!