The refrigerator when it is cold (I started doing an ICT every so often - one night I found everything defrosted, the ice cream. I was not walking, now I am seeing that the refrigerator vent that is in the form of a mailbox strip turns slowly - what do I do? THANK YOU

Hi Monica, the first thing I tell you is that that called fan of corkscrews, is not the main fan, is really called multi-flow and its function is only to make a better distribution of cold air and does not work at high revolution, Your job is slow but fluid. The main fan is hidden in the frezzer, behind the plastic cover of what would be the back wall. The click that has been heard occasionally, could well be producing thermal protection when opening the passage of current to the compressor, by a failure of the relay or a capacitor of the compressor in case you use it, so it would have to be measured with a tester or multimeter, to check if one of them has been devalued, to the point of making the compressor sometimes not start correctly. Time can also test that kind of click, said Time, is a kind of clock that takes the equipment to defrost every 6 or 8 hours, to eliminate all the frost that is hidden in the evaporator (frezzer) of the system. If Time begins to fail, it obviously stops doing the aforementioned function and that implies that the refrigerator closes all the air ducts due to the excess of frost or ice that would accumulate, including the evaporator itself, while preventing Cold air flows throughout the interior of the equipment and obviously causing poor cooling of the food stored inside. If the refrigerator is now out of work, the thermal fuse that is connected in series with the defrosting resistor should also be checked, as well as the resistance itself that also opens, both elements are also hidden inside the frezzer and if they fail , they will also prevent feeding to the Time, causing in the same way the loss of cold. Check them out. To speed up defecation, use a domestic fan, disconnect the power supply and place the fan at the height of the frezzer and as close as possible to the entrance of the frezzer. This procedure is to speed up if you need to verify the good condition of the resistance or any other element inside the refrigerator. S @ lu2 friovega63.