⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥
Refrigerators

White Westingouse refrigerator mod. W338NF

Laura Fangmann
hace 6 años
hace 6 años
[size=140] Good afternoon, my refrigerator ww model W328NF, which is 5 years old, started losing water two weeks ago. The water leaves the freezer to the internal part of the refrigerator through holes that are in the inner "roof" of the refrigerator ... is like a leak. Sometimes you lose and sometimes you don't. Ppr else cools well up and down. What can be? How do I solve it? [/Size]
lusangor
lusangor
56.366
hace 6 años
hace 6 años
Hello Possibly have a lot of ice, defrost it completely when you can and try again Regards
Laura Fangmann
hace 6 años

Thank you. I just did that. Take out a floor in the freezer and there was ice. So I cleaned everything and plugged it back in. We will see! Thank you!!

Responder
friovega63
friovega63
11.849
hace 6 años
hace 6 años
Hi Laura, maybe your refrigerator should just give you a backward tilt, using a bubble level, and create a drop of half a drop or bubble. In addition, you should raise the temperature range of the storage zone a little more for greater cold, moving the thermostat or temperature control, to maximum cold, then if stored products, which you do not want to freeze, such as milk or the egg. Go down for days, little by little the thermostat for less cold, without reaching the starting point, where you are now, because you have not done anything. Continue, until an adequate indoor ambient temperature is reached, so that the same problem does not return, to the humidity contained in the hot air, which enters the conservation zone, each time the door is opened and closed and said air collides with the cold walls and surfaces of that compartment in your refrigerator, causing condensation or sweat, which ends up looking like rain. We observe the same effect when we take a cold can of cold soda out of the refrigerator and see that as it heats, it begins, as if to sweat. Also, a cleaning to the internal drainage system of the equipment, from the inside of the frezzer, to the water collector tray, located at the rear or at the lower outer part of the equipment must also be added. Luck. S @ lu2 friovega63.
Laura Fangmann
hace 6 años

Thank you!!

Responder
friovega63
friovega63
11.849
hace 6 años

Thank you for the communication. S @ lu2 friovega63.

Responder
Fermin 007
Fermin 007
57.307
hace 6 años
hace 6 años
Defrost the drain hole, pour boiling water until it uncovers and the water falls down to the defrosting tray, often with that it has and places the temperature control on an average, never to the maximum, that is a garrafal error , Cheers
Clima Bueno
Clima Bueno
3.681
hace 6 años
hace 6 años
Good morning Laura, let's see ... If you had 5 years and worked well during that time is that now something is wrong. Surely it forms ice for what colleagues say but ... why? Maybe you are not draining the water from the thaw and it is stuck until ice forms, so you should check the drainpipe and the defrost system. Regards
Reparaciones similares solucionadas

¿Conoces una solución?

¡Aprende a reparar con estos cursos YoReparo!

4.93
(14)

Curso Reparación de Equipos de Audio de Alta Fidelidad

Maximiliano Resch
$ 60 USD
$ 20 USD
4.71
(7)

Curso TV OLED y QLED con el Ing. Picerno

Ing. Alberto H. Picerno
$ 29 USD
$ 10 USD
4.64
(11)

Curso Electrónica para Reparación de Placas

Santiago Cediel
$ 29 USD
$ 11 USD
¿Tienes una mejor respuesta a este tema? ¿Quieres hacerle una pregunta a nuestra comunidad y sus expertos?
Regístrate gratis