Hello everyone, my Mabe RMA1130VMF refrigerator drips inside the part where the light bulb is underneath, it has holes through which water comes out, it has been with me for two years and it has never done that, it started doing it a few days ago and I am worried because I don't know if it can be normal, but it bothers me because I have to dry all that water that supposedly he should recycle not? Therefore I would like to know if it is a problem or if you can configure something on the computer, without further greetings to all.

Hi Leandry, first disconnect the refrigerator from the power line and use a domestic fan, place it as close as possible to the entrance of the frezzer at the top. All this is to speed up the rapid defrosting of the accumulated frost, keep the fan for 6 or 8 hours, depending on the ambient temperature, if there is more cold weather and if there is less heat. After this process has passed, you must remove the cover or tray of the frezzer that conceals the evaporator coil and locate the hole of the drain conduit, which should be just below the evaporator, through this conduit you should try to pass a tape or cable , with the strength and flexibility, necessary at the same time as allowing it to be introduced through the entire drainage duct from inside to outside to said belt, to ensure proper cleaning, adding abundant water, so that it can carry with it any particle that can have been clogging the drainage system. Then with a level of bubbles, you must rectify the inclination or fall, backwards that type of refrigerator should always have, the ideal would be to give it half a drop of level in the backward inclination, this would even help to a better closing of the doors. Finally, raise the temperature control or thermostat, in the lower part of the storage area, regulating it for more or more cold. If you faithfully comply with everything I recommend, you will undoubtedly resolve your situation with the refrigerator. Luck. S @ lu2 friovega63.

Hello... In addition to the solutions of the partners regarding the issue of drainage, in case it does not work for you, you should replace the piece of ico because it is dividing the doors, these at the end of its useful life are immersed in water and cause this problem. Another point is that you should observe the inclination of the refrigerator should be a little, just a little pulled back so that the drain works perfectly. To prevent this failure when placing products in the freezer should always be well covered. Regards.