⚡ Descuentos en cursos en video - Lleva tu aprendizaje técnico al siguiente nivel y aprovecha precios especiales antes de que termine la oferta. 🔥 Aprovechar oferta ahora 🔥

Refrigerators

How to change the straightness and starter in Briket exibidora

rdoming

hace 6 años

I would like to change the fluorescent tube that the exibidora brings with one of LEDs. The issue is that I must cancel the straightness and the starter and they are not in sight. Anyone know where they are located in this unit? The tube is at the top, in the front, but they are not visible the starter and the straightness.

Comentar



Clima Bueno

3.681

hace 6 años



hace 6 años

Did you check if it is not in the compressor area? Regards

Comentar

rdoming

hace 6 años

Hello! I checked the area of the compressor and although the reluctance was not there and the starter could see them from that position since they are in the front part of the cabinet just under the door and behind a gray plastic sight that is used for ventilation .
So I closed the compressor grill, put the exibidora back in its place, removed the gray plastic from the front under the door and accessed the straightness and the starter that annulled and installed the LED tube without problems.
Thank you very much for the suggestion, it served me.



Responder

Clima Bueno

3.681

hace 6 años

Perfect, better then. Regards



Responder

Fermin 007

57.307

hace 6 años

Upload an image of the display, if you do not find it, cut the cables and insulate them and place a new installation with a power outlet and a damper you take it from the main cable of the equipment, nothing happens if you leave the ballast and the starter, maybe it comes integrated at the base of the same fluorescent lamp, so many of those fluorescent lamps come.

Comentar